Tractor & Construction Plant Wiki
Loyd Carrier
Loyd TT towing a 6 Pdr anti-tank gun, outside 's-Hertogenbosch 1944
Type Armoured personnel carrier
Place of origin  United Kingdom
Service history
In service 1939 -1960s
Used by British & Commonwealth.

Post-war Danish, Dutch and Belgian armies

Wars Second World War
Production history
Designer Vivian Loyd
Designed 1939
Manufacturer see text
Produced 1939 -
Number built 26,000
Variants Mark 1, Mark 2
Weight 4.50 t (4.43 long tons)
Length 13 ft 11 in (4.2 m)[1]
Width 6 ft 9 in (2.1 m)[1]
Height 4 ft 8 in (1.4 m)[1]
Crew 1

Armour up to 7 mm where fitted
Engine Ford V8 Side-valve petrol
85 bhp (63 kW)
Power/weight 18.9 hp/tonne
Transmission Ford 4 forward, 1 reverse gearbox[2]
Suspension Horstmann twin wheel bogies
Ground clearance 8 inches[2]
Fuel capacity 22 gallons[2]
140 miles (220 km) on roads
Speed 30 mph (48 km/h) maximum on road
braked - two drums per track

The Loyd Carrier was one of a number of small tracked vehicles used by the British and Commonwealth forces in the Second World War to transport equipment and men about the battlefield. Alongside the Bren, Scout and Machine Gun Carriers, they also moved infantry support weapons.

Design and development

The Loyd Carrier was built upon the mechanicals (engine, gearbox and transmission) of a 15 cwt 4x2 Fordson 7V truck with mild steel bodywork to which armour plate (referred to as 'BP Plate' in Loyd manuals) was bolted (to the front and upper sides) depending on application. The engine was at the rear of the Carrier with the radiator behind rather than in front. The transmission then took the drive forward to the axle at the very front where it drove the tracks. Both the front drive sprockets and idlers (which were also sprocketed) at the rear of the tracks were fitted with brakes, actuated by a pair of levers by the driver. To turn the vehicle to the left, the brakes were applied on that side and the Carrier would slew round the stopped track.

The upper hull covered the front and sides but was open to the rear and above; as the Carrier was not expected to function as a fighting vehicle this was not an issue. To protect the occupants from the weather a canvas tilt could be put up; this was standard fitment from the factory. [3]

As part of the rapid development program and use of pre-designed parts the Loyd used parts from other vehicles. From the Universal Carrier the track, drive sprockets, and suspension units. From the Fordson 7V, the chassis, engine, gearbox, torque tube, axle and brakes[3]

The Army tested the Loyd Carrier in 1939 and placed an initial order for 200 as the Carrier, Tracked, Personnel Carrying i.e. a personnel carrier. Initial deliveries were from Vivian Loyd's own company but production moved to the larger firms including the Ford Motor Company and Wolseley Motors ( 13,000 between them) and Dennis Brothers Ltd, Aveling & Barford and Sentinel Waggon Works. Total production of the Loyd Carrier was approximately 26,000.[citation needed]


Second World War

By far the most notable use of the Loyd was in the TT (Tracked Towing) configuration where it pulled the 6 Pdr anti-tank gun from the Normandy landings of 1944 through to the end of the War. There are many wartime photographs of Loyds in action in Normandy, a number were photographed destroyed in the well-known battle of Villers-Bocage in 1944. The Loyd Carrier was paired with Caterpillar D8 tractors in service with Royal Electrical and Mechanical Engineers (REME) for tank recovery - the Carrier carrying spare equipment for the tractor.


Both Belgium and the Netherlands brought Loyd TTs from the British Army; they were still in Belgium Army ownership up to at least 1963 as engine rebuild plates have been seen with this date in original Belgian vehicles.[4] Although some vehicles were sold on into private ownership for farming use (A 1941 No1Mk1 TPC with a ploughing conversion still exists in Nottinghamshire, UK), a number were placed as targets on Belgian Ranges.


Loyd carriers were available in three "numbers" which were available in two "marks"; all manufactured during wartime:[3]

  • No. 1 - British Ford V8 engine (21 stud) and gearbox
  • No. 2 - US Ford V8 engine (24 stud) and gearbox
  • No. 3 - Ford Canada V8 engine (24 stud) and gearbox

The two marks were the Mark I with a Bendix supplied brake system and the Mark II with Girling supplied System


There were not many differences between variants, mainly seating and armour plate location:[3]

Tracked Personnel Carrier (TPC)
Equipped with a front bench seat and seating for troops on the track guards. Frontal and full side armour fitted.
Tracked Towing (TT)
Equipped with five single seats and ammunition stowage on the track guards. Used for towing the 4.2 inch mortar and hauling the QF 2 pounder and QF 6 pounder anti-tank guns and carrying its crew. Frontal and front quarter armour fitted. The main variant by number manufactured.
Tracked Cable Layer Mechanical (TCLM)
A vehicle for Royal Signals Corps work. No armour fitted.
Tracked Starting and Charging (TS&C)
Equipped with a front bench seat, 30 volt and 12 volt DC generators driven from the gearbox layshaft and battery sets to support armoured regiment tanks. No armour fitted.
Tractor Anti-tank, MkI
Towed the QF 2-pdr anti tank gun[5]


  1. 1.0 1.1 1.2 WWII Vehicles
  2. 2.0 2.1 2.2 WWII Equipment
  3. 3.0 3.1 3.2 3.3 PartsBook
  4. HMVF


External links

Wikimedia Commons has media related to:
v · d · e British Commonwealth armoured fighting vehicles of World War II
Flag of the United Kingdom.svg
British armoured fighting vehicle production during World War II
Smallwikipedialogo.png This page uses some content from Wikipedia. The original article was at Loyd Carrier. The list of authors can be seen in the page history. As with Tractor & Construction Plant Wiki, the text of Wikipedia is available under the Creative Commons by Attribution License and/or GNU Free Documentation License. Please check page history for when the original article was copied to Wikia