|This article relies largely or entirely upon a single source. Please help improve this article by introducing appropriate citations to additional sources. (January 2013)|
|This article needs additional citations for verification. Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. (January 2013)|
|AEC Regent III RT|
Preserved RT 2177 outside Uxbridge tube station, 4 July 2004
|Operator(s)||London Transport and others|
|Floor type||Step entrance|
|Options||Various customer options|
The prototype (London Transport RT 1) was built in 1938 with AEC's 8.8-litre engine (a stopgap measure until the new 9.6-litre was available) and air-operated pre-selective gearbox. Finding a satisfactory British substitute for the German air compressor, bought from Bosch, was to cause problems for AEC, once war broke out. A prototype chassis was placed into service, disguised as an old vehicle. It carried a secondhand open-staircase body previously carried on Leyland Titan (fleet number TD 111), dating from 1931. Thus bodied, RT 1 entered service in July 1938 as ST 1140, even though it was nothing like a standard ST vehicle. It continued in service until December 1938.
While the chassis was on trial, a new body was constructed at London Transport's Chiswick works. Its four-bay body resembled that of the conventional Roe body exhibited at the 1937 Commercial Motor Show, though the overall impression of modern design and the features included marked a big step forward. This body replaced the old one on RT 1 and the bus re-entered service in 1939.
Pre-war production vehiclesEdit
London Transport ordered 338 (later cut to 150) chassis which were in production when the war broke out in September 1939. The last of the batch, RT 151, did not reach London Transport until January 1942. The only other RT-type chassis constructed before the end of the war was destined for Glasgow, originally intended to be an exhibit at the 1939 Commercial Motor show, but cancelled due to the outbreak of war. It differed from the pre-war London examples in having a body built by Weymann, though the cab area was very similar to the London vehicles.
Post-war production vehiclesEdit
Production of the RT recommenced in late 1946, being delayed by London Transport's wish to have the bodies jig-built, following its experience building Halifax bombers at Aldenham Tube Depot (later to become its main bus works). The new vehicles were built to a modified version of the pre-war London Transport design, but were similar in appearance to their predecessors. The main visual differences were:
- The ultimate (narrow) destination blind was now located just above the driver with the via blind (wide) between the ultimate and the top deck windows.
- The front route number remained above the top deck windows (known by some as the lighthouse box...as well as the more widely used roofbox) although the rear one was removed and the route number joined the 'via' points in the main display.
- The bodywork was constructed by contractors rather than by London Transport.
- The lower edge of the cab window forward of the driver's door and the lower edge of the driver's windscreen were horizontal, whereas on pre-war examples they curved downwards towards the corner of the cab. Also, the lower offside bodyside, behind the rear wheel, did not curve is, as that before the rear wheel.
- The number of ventilation slats below the windscreen was reduced from 6 to 4.
In total, London Transport received 4,674 post-war RT-class buses between 1947 and 1954, with a small number of similar buses being sold to operators outside London (see below).
However, the London "RT" family of vehicles could be considered to have numbered 6,956 in total, consisting of 4,825 RTs; 1,631 RTLs and 500 RTWs. The latter two types had a variant of the Leyland Titan chassis and, in addition, the RTW's had Leyland 8 feet wide steel framed bodies (as opposed to 7 feet 6 inches). The whole family were never all in operation at the same time.
Like the pre-war Glasgow vehicle, not all post-war production went to London Transport. Between 1946 and 1951, 101 chassis were delivered to ten other operators. Of these, only forty had RT-style bodies, thirty nine, by Park Royal, for St Helens Corporation and one, by Metro-Cammell, for Coventry Corporation. The external link below has more information.
Notable appearances in moviesEdit
An RT-series bus was featured in the James Bond movie, Live and Let Die. He commandeers it and engages in a vehicle chase across the fictional Caribbean island of San Monique.
- AEC Regent III
|This page uses some content from Wikipedia. The original article was at AEC Regent III RT-type. The list of authors can be seen in the page history. As with Tractor & Construction Plant Wiki, the text of Wikipedia is available under the Creative Commons by Attribution License and/or GNU Free Documentation License. Please check page history for when the original article was copied to Wikia|